Challenge:Inspiration :

Challenge : Create a project using the photo as your inspiration & making it "All a Flutter - Add a butterfly".

The project can be a card, a scrapbook layout or off the page project......it's totally up to you!

 

 

I Have made these two cards for the Scrapbook Boutique Challenge, I wasn't going to enter this month due to illness, but I had to make a thankyou and Birthday card so thought I might as well do it for the challenge

It is hard to know what to do for a male thankyou card, so I decided to use the print of the paper to make it a bit easier.

I have used masking tape for the birds on the wire.

The butterfly and dragonfly have be stamped onto acetate sheets using staz-on, allowed to dry then cut out.

I bent the wings to give them a 3D effect and glued the bodies onto the paper.

I hope he likes his card!!!!!!

The birthday card is for a girlfriends birthday

I did both card using only one sheet of printed paper, that includes the insides as well.

 

 

 This is the side veiw of the card to give you a idea of the butterflies and dragonfly in 3D

 The inside of the thankyou card

 This is the birthday card in 3D and below the inside of the card